[ELECTRON] Update on reprap

[Roy Mohan Shearer]

Are we still in need of a bit of plywood for this? can drop off an 8mm
piece cut to size if so.
Roy

On 5 May 2012 21:15, Kieran Wyse <kieranwyse at gmail.com> wrote:
> Bob we are likely to put a heat bed on it, I am not sure how perspex would
> take to the heat of the bed. I suspect wood will do better but could be
> wrong.
>
> Thanks for looking
>
> Kenny if no one has any, I am sure that I can pick up an offcut at B &Q if
> no one has any lying around.
> Kieran.
>
>
>
> On 5 May 2012 17:59, Kenny Duffus <kenny at duffus.org> wrote:
>
>> On Saturday 05 May 09:35:34 Kieran Wyse wrote:
>> > Thinner the better, but not so thin it is not rigid ... I don't know how
>> > thin ply could be and still be riggid. It is to create the bed for the
>> > prints so needs to be rigid. The bed moves so the heavier it is the
>> harder
>> > to move. If the 3mm ply is rigid that sounds ideal.
>> >
>>
>> i think the 3mm ply i have is not quite rigid enough unfortunatly
>>
>> --
>>
>>        Kenny
>>
>> _______________________________________________
>> members mailing list
>> members at electronclub.org
>> http://www.electronclub.org/cgi-bin/mailman/listinfo/members
>>
>> Instructions for changing your mailing list settings:
>> http://lists.electronclub.org/emailhowto.html
>>
>> Archive for this list:
>> http://lists.electronclub.org/pipermail/members/
>>
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <http://www.electronclub.org/pipermail/members/attachments/20120505/28efb9c1/attachment.html>
> _______________________________________________
> members mailing list
> members at electronclub.org
> http://www.electronclub.org/cgi-bin/mailman/listinfo/members
>
> Instructions for changing your mailing list settings:
> http://lists.electronclub.org/emailhowto.html
>
> Archive for this list:
> http://lists.electronclub.org/pipermail/members/