[ELECTRON] Goshg meeting 2nd of august.

[Kieran Wyse]

Goshg Meeting Thursday 2nd august

We achieved a lot in the last session.

We got the printer moving in all 3 axis. Had a minor issue with one of the
x axis and had to route it through a different pin.

We upload marlin to the arduino board.

The z axis was not homing or scaling properly, we discovered that we needed
jumpers on the reprap sheild. We will do this on the next sesssion.

The heater on the extruder seems to be working.

The heat bed seems to be working as expected.

We corrected a miss-wiring of the fan and the thermistor on the extruder.
We also replaced the fan, it was giving out more heat than air.

The next stage will start test extrusions.

Mark made a time lapsed film of our progress.

http://www.flickr.com/photos/nand/7700808360/

Next meeting will be Thursday the 16th of august

Kieran.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.electronclub.org/pipermail/members/attachments/20120806/55bb90bb/attachment.html>